Clocking

Packet time is not conversion time.

The receiver’s audio clock determines FIFO reads and DAC cadence. Ethernet timing is recovered independently for transport. A buffer helps manage packet variation; it does not erase a permanent rate mismatch.

Proposed O2AT clock acquisition and reference-loss lifecycleAn open session may acquire a valid local or disciplined clock. Start is allowed only after timing and the required source relationship are valid. Valid bounded holdover may continue. Invalid timing, exhausted holdover, or a missing playout packet causes local mute or abort, followed by a fresh session after recovery.OPENsession may acquireCLOCK VALIDrelationship checkedSTARTthen prefillRUNNINGlocal conversionMUTE / ABORTlocal protectionHOLDOVERonly within declared boundRECOVERYnew session requiredvalid STARTinvalid / timeoutreference lossreference restoredvalid bounded holdover
A status message must not delay local protection or authorise an automatic restart. After mute or abort, establish a fresh session.

Three operating cases

Rate control depends on the source.

Receiver-paced elastic source

The receiver grants a cumulative group limit. The source can pace production in response, while outstanding data in flight remain inside the grant. Duplicate grants do not add credit; an older grant does not retract the current one.

Common-frequency live source

When source and receiver share a disciplined reference, the design may keep long-term rates related. This must be measured as bounded FIFO occupancy and relative drift. A shared 10 MHz reference establishes frequency discipline, not a shared sample epoch.

Independent fixed-rate live source

A producer whose clock cannot be controlled eventually fills or drains any finite buffer when its rate differs from the receiver. Credits cannot change that physical clock. The system must provide valid conversion, a declared bound, or safe rejection and mute behaviour.

A finite margin

Buffering delays a mismatch. It does not remove it.

For relative frequency error ε, available margin M sample groups, and group rate r, approximate time to a buffer limit is M / (r × |ε|). A 1 ms margin at 50 ppm lasts about 20 seconds without correction.

Packet phase, network delay, packet reserve, source response time, processing stalls and in-flight frames affect first-failure timing. The 20-second value is analytical and does not predict a hardware measurement.

The reference tier shall provide a specified external 10 MHz input, independent audio clock generation, lock monitoring and controlled holdover. Entry-level operation can use an internal oscillator with receiver feedback. Invalid timing or expired safe holdover causes local mute or abort. A STATUS message does not delay protection or trigger automatic restart.

For raw DSD, an all-zero bitstream can create a large DC condition. Use converter mute or a validated DSD idle/transition sequence; do not substitute zeros as a generic mute.

Measurement

Claims require clock and occupancy evidence.

The draft calls for output frequency and uncertainty, relative drift, phase-noise spectra with stated integration limits, discrete spurs and time-domain period or phase error. Testing must cover both frequency families, local and external-reference modes, idle and admitted traffic, temperature changes, reference interruption and reacquisition.

Log FIFO occupancy and cumulative group counts during the same tests. A synthesiser’s lock signal is not a substitute for showing bounded occupancy, safe holdover or upstream rate control. None of those prototype measurements is claimed as complete.

Open the illustrative FIFO laboratory →